	Professional Series Dimmer Range, 2 Channel 10A

L5102D10 2 Channel Dimmer, 10A

£472.89

£555.65

						Provides 2 x 10A channels of dimming control Programmable via the learn mode feature or using the C-Bus Toolkit Software Programmed variables are stored in non-volatile memory and are retained in case of loss of mains or C-Bus power Local and remote on/off control independent of C-Bus communications Programmable power up state following power cycling Logic states (max/min) programmable using the C-Bus Toolkit Software Employs frequency-tracking algorithms for smooth flicker free operation Soft start on power up, for increased lamp life Features auxiliary contacts which close on thermal overload or overcurrent condition RCM (Australia/New Zealand), CE (European Community) compliant			Catalogue Number L5102D10 Line Supply Voltage 220-240VAC Supply Frequency 47-53Hz and 57-63Hz Frequency Drift 3Hz/minute (maximum) Frequency Step Change 0.1Hz (maximum) C-Bus Supply Voltage 15-36VDC @ 0mA Load Rating per Channel 10A Overcurrent Shutdown 12A Minimum Load 100W per channel Current Sensing 5-100% of full rated load, 5% accuracy Control Range 2 - 98% Compatible Loads Incandescent and low voltage lighting. Suitable for use with leading edge compatible electronic transformers. C-Bus Source Current 60mA Maximum Number of Units on 30 a Single C-Bus Network Status Indicators Channel Status (2), Unit and C-Bus Warm Up Time 5 seconds Network Clock Software selectable Network Burden Software selectable C-Bus Termination 4 way removable screw terminal Load Termination 2 x 2.5mm2 or 1 x 4mm2 Auxiliary Contacts Normally open, 2.5A, 240VAC, voltage free, resistive Operating Temperature Range 0˚C to 45˚C Operating Humidity Range 0 - 95% RH, non-condensing
		Please click here for a larger image



		NEW! Black and White Touch Screen


									The C-Bus 2 channel dimmer units are panel mounted units employing leading edge phase control circuitry, with soft start for dimming control. These dimmer units feature learn mode, local and remote overrides for on/off control, channel, C-Bus and unit status indicators. Each dimmer channel is rated at 10 Amps and is suitable for incandescent and low voltage lighting using magnetic and leading edge compatible transformers. Software algorithms found in the units, continuously monitor the incoming line voltage and automatically compensate for any changes in the voltage level by adjusting the output drive to the load. In addition frequency-tracking algorithms ensure fl icker free operation and smooth dimming control. The dimmer is constructed from an oversized, rugged, anodized aluminum heat sink to dissipate any heat build-up in the unit. In addition the dimmers employ thermal overload and overcurrent protection, to protect the dimmer and load in case of a fault condition. The dimmer units source 60mA to the C-Bus network, which means for small networks additional C-Bus power supplies are not required.

			KEY INPUT UNITS \| INPUT UNITS \| SYSTEM UNITS \| OUTPUT UNITS \| WIRELESS \| AUDIO \| SOFTWARE \| DESIGN GUIDE home \| about us \| online shop \| contact us
	©2008 C-Bus Direct, a division of LDS Co. Reg 5514263 Unit 8, Vision House, Kingfisher Business Park Blashford Ringwood Hants BH24 3NX 01425 478395 designed by eberlin

OutputUnits1

C-Bus Direct: The official national distributor and online shop for Clipsal C-Bus products. Serving the Poole and Bournemouth areas for several years.